How to install your HashyLink into your Xiros Mikros freeze dryer.

Video guide

I promise your install will be 100x easier if you watch this

I promise your install will be 100x easier if you watch this

Step 1

Turn off/unplug your freeze dryer

Step 2

Pull the back panel and metal shroud off

You’ll need to unscrew all of the stainless screws along the bottom and back of the machine

Also make sure your vacuum hose is able to pass freely through the shroud hole! Remove your clamp and unscrew the connection point

Step 3

Connect the wires to the back of the PLC

There are five wires to connect in total, all of them are labeled with the proper connection point on your freeze dryer

Watch the video to see where everything plugs into

All the wires are labeled! Just match them up on the back of your HGS screen

All the wires are labeled! Just match them up on the back of your HGS screen

Step 4

Make sure your aren’t touching any exposed wires

Plug you freeze dryer back in and turn it on

Carefully scan the QR code (using the SoftAP app below) on the bottom of the HashyLink and go through the Wi-Fi setup instructions

  1. Download ESP SoftAP Provisioning
  2. Open ESP SoftAP Provisioning app and scan QR code